Skip to content
AYARUX

Work-and-turn vs work-and-tumble: how the sheet turns on the press

On any job printed on both sides, the first decision is how the sheet turns on the press. Are front and back printed from separate plates, or do they sit side by side on one plate while the sheet is turned? That choice changes the number of plates, the page layout and the gripper margin all at once. This guide explains the four methods and when each one fits.

Last updated:

Sheetwise (separate plates)

The most straightforward method: the front is printed with one set of plates, and once the sheets are dry the back is printed with a second set. A 4/4 job needs eight plates.

Each side can use the whole sheet, so it suits large jobs, long runs and layouts where only one side fits on the sheet.

Work-and-turn

Front and back are laid side by side on the same plate. The sheet is printed once, turned side to side and printed again with the same plate. Every sheet yields two complete sets and the plate count is halved: a 4/4 job prints from four plates.

In work-and-turn the leading edge of the sheet stays the same for both passes, so the gripper edge does not change. It is the usual method for business cards, flyers and short-run leaflets.

Work-and-tumble

Front and back again share one plate, but the sheet is turned head over tail, so the tail edge becomes the leading edge. It is used when the long edge does not fit the press or the layout calls for it.

The point to watch: on the second pass the opposite edge of the sheet becomes the gripper. A gripper margin has to be left on both edges, the usable area shrinks, and on a borderline job the number of pieces that fit can change.

Perfecting presses

Presses with a perfecting unit turn the sheet inside the press and print both sides in a single pass. There is no waiting for the first side to dry, but each side still needs its own plates, so the plate count is the same as sheetwise.

Which method for which job?

Run length, sheet size, the press and the job itself decide. A rough guide:

  • Short run, small piece, two sets fit on the sheet: work-and-turn, half the plate cost.
  • Long edge does not fit the press or the layout needs head-to-tail: work-and-tumble, with a gripper margin on both edges.
  • Large piece, long run, only one side fits: sheetwise.
  • The press has a perfecting unit and speed matters: perfecting.

Common mistakes

In a turned job, front and back have to be rotated correctly relative to each other; get the turning direction wrong and the back prints upside down or shifted. Leaving a gripper margin on one edge only in work-and-tumble is another frequent mistake; when it is caught at the press, the plates are made again.