Skip to content
AYARUX

How many printing plates does a job need? Colours, sides and signatures

In offset printing every colour needs its own plate for each side of the sheet. The plate count is one of the fixed costs in a quote: on short runs it shapes the unit price more than anything else. The sum is a simple multiplication, but the printing method and the signature plan can double the result or halve it.

Last updated:

The basic sum

The number of plates for one side of a sheet equals the number of colours on that side. A four-colour (CMYK) side takes four plates; a one-colour side takes one.

For the whole job, add the front and back colours of each signature, then add the signatures together. A single-signature 4/4 job (four colours front, four back) takes 8 plates, a 4/1 job takes 5 and a single-sided 4/0 job takes 4.

Signatures multiply it

In books, magazines and catalogues the pages are split into signatures, and each signature needs its own set of plates. A 16-page job in four colours on both sides, split into two 8-page signatures, needs 2 signatures × 2 sides × 4 colours = 16 plates.

If the same job fits one signature on a larger sheet, the count drops to 8. That is why sheet size and signature plan change the plate bill before they change the paper bill. If the cover prints separately, its plates are added too.

The printing method changes the count

Sheetwise printing uses separate plates for front and back, so two sets are needed. A perfector prints both sides in one pass; that saves a pass through the press, but each side still has its own plates.

In work-and-turn the front and the back sit side by side on the same plate: the sheet is printed on one side, turned, printed again from the same plate and then cut in half. One set of plates is enough. In exchange the job has to fit on half the sheet, and in work-and-tumble the gripper edge changes as well.

  • Sheetwise, 4/4, one signature: 8 plates.
  • Work-and-turn, 4/4, one signature: 4 plates.
  • Sheetwise, 4/4, two signatures: 16 plates.

Extra colours and varnish

Every spot colour (a corporate Pantone, for instance) means one more plate for the side it prints on. Running a spot colour separately when it could be converted to CMYK comes back as plate and make-ready cost; how critical the colour is decides it.

Finishes applied to a defined area, such as spot varnish, often need a plate or blanket of their own. For an overall dispersion coating it depends on the press; the printer running the job is the one to ask.

What it does to the cost

Plate cost doesn't depend on quantity: 500 copies or 50,000, the number of plates is the same. On short runs plates and make-ready make up a large part of the unit cost, and they are usually what sets the break-even point between offset and digital.

On very long runs a plate can wear out and need remaking; the limit depends on the plate type and the stock, so ask the printer.

A checklist before you count

Settle these before the plate count goes into the quote:

  • How many colours on the front and on the back? Is there a spot colour left in the file unnoticed?
  • How many signatures, and is the cover separate?
  • Sheetwise or work-and-turn?
  • Does a varnish or another finish need its own plate?