Skip to content
AYARUX

What is a colour control strip? Measuring density, dot gain and grey balance in print

Along the edge of an offset sheet there is a thin row of coloured patches that ends up in the bin after trimming: the colour control strip. The client never sees it, but it is where the press operator measures whether the colours are printing correctly.

Last updated:

What is a colour control strip for?

Judging colour by eye on an image is hard, because every image is different. A control strip carries the same patches at known values on every job. The operator reads them with a densitometer or spectrophotometer and sets the ink by the numbers.

That way you can check that the colour doesn't drift from the first sheet to the last, and that two print runs on different days give the same result.

Which patches are on the strip?

Strips vary by maker and standard, but most repeat these kinds of patch:

  • Solid patches (C, M, Y, K at 100 per cent): to measure ink density.
  • Tint patches (for example 40 and 80 per cent): to see dot gain, how much the dot grows on press.
  • Grey balance patches: to see whether a grey built from three colours stays neutral.
  • Overprint patches (two colours together): to see how well one ink traps on top of another.
  • Slur and doubling patches: fine lines that show whether the dot is being stretched.

Where does it go on the sheet?

The strip usually runs across the tail edge of the sheet, at right angles to the ink flow, covering every ink zone of the press. Having a patch under each ink zone lets the ink be set zone by zone.

The strip must sit in the trim area, outside the finished job. So the imposition has to leave enough space at the sheet edge for it; otherwise the strip either lands on the work or doesn't fit at all.

Leaving room when imposing

The gripper margin takes one edge of the sheet and the tail margin the opposite edge; the strip usually sits in one of them. Pushing the margins towards zero to fit one more row is tempting, but with no room for the strip the colour can't be measured.

Digital presses use their own calibration, so a strip isn't needed on every job. The best move is to ask your printer which strip and which measurement they use before you start.