Skip to content
AYARUX

How to calculate spine width: the formula and a worked example for books and catalogues

You can't finish the cover of a perfect-bound book until the text is settled: without the spine width, the open cover size is unknown too. The sum is simple, but it has to be redone whenever the paper or the page count changes.

Last updated:

The basic formula

Each leaf is two pages, so find the number of leaves first and multiply by the thickness of one leaf:

Spine width = (page count ÷ 2) × paper thickness

Use only the text paper here, not the cover. Blank pages count as well, because they add to the spine.

Grammage alone doesn't give thickness

Two papers of the same weight can differ in thickness. The value that links them is bulk, which the paper maker lists on the data sheet:

Paper thickness (mm) = grammage × bulk ÷ 1000

Coated paper is dense and stays thin for its weight. Uncoated offset is thicker, and book papers are light but bulky.

  • Uncoated offset 80 gsm, bulk about 1.25: about 0.10 mm per leaf.
  • Coated 115 gsm, bulk about 0.8: about 0.09 mm per leaf.
  • Bulky book paper 70 gsm, bulk about 1.8: about 0.126 mm per leaf.

A worked example

A 240-page A5 book (148 × 210 mm) on 80 gsm uncoated, with a leaf thickness of 0.10 mm:

(240 ÷ 2) × 0.10 = 12 mm. Depending on the bindery, about 0.5–1 mm is added for the glue, so the cover spine is often set at 12.5–13 mm.

  • Open cover width: 148 + 13 + 148 = 309 mm.
  • With 3 mm bleed: 315 mm.
  • Open cover height: 210 + 6 = 216 mm.

Confirm it with a dummy

The formula gives a good estimate, but the paper you actually print on decides the final number. Bulk can vary a little between batches, so on large jobs a bound dummy made from the real stock is the safest way to measure the spine.

On thick jobs, ask the bindery for the final figure before printing the cover. A few millimetres of error can push the spine text onto the front cover.

Spine text and cover design

Very thin spines don't take text; below roughly 3–4 mm it's unreadable and prone to drifting. Centre the text on the spine and leave at least 1 mm on each side.

Mark the spine lines as guides on the cover, and remember to update it if the page count or the paper changes.