Last updated:
What is the tail margin?
The tail margin is the unprinted strip along the trailing edge of the sheet, opposite the gripper edge. As the sheet leaves the cylinder its back edge is free; ink may not lay down evenly in those last millimetres, the paper can flutter and it can rub on the delivery.
That is why no work is placed on the back edge; the print area is what lies between the gripper margin and the tail margin.
How it differs from the gripper margin
The gripper margin is the edge the sheet is held by; nothing can print where the grippers bite, and the figure is fixed for each press. The tail margin is on the edge that is not held, and it is left mainly for print quality and a clean delivery.
The two are not always equal. On many presses the gripper margin is around 8–12 mm and the tail margin around 3–8 mm, but these are only examples; your own press's values are what count.
- Gripper margin: the leading edge, where the sheet is held.
- Tail margin: the trailing edge, the last unprinted strip.
- Side margins: the blank on either side, usually narrower.
How many millimetres?
The right figure comes from the press itself. The maximum print area in the catalogue is a starting point; printing a solid on a blank sheet and measuring where the ink ends cleanly at the back edge is the most reliable way.
On heavy board, large solids or varnished work, a slightly wider tail margin avoids trouble. If the shop runs several presses, record the tail margin of each separately.
What happens to it in work-and-tumble?
In work-and-turn the sheet is turned side to side, so the gripper edge stays the same and the tail stays at the back. In work-and-tumble the sheet is turned head over tail: the back edge becomes the leading edge on the second pass and is held by the grippers.
Both edges then need a full gripper margin; if the back edge only has a tail margin, the grippers land on the work on the second pass. When work-and-tumble is chosen, impose with a gripper margin on both edges.
Allowing for it in imposition
When you work out how many pieces fit, the gripper, tail and side margins come off the sheet size; what remains is the print area. Forgetting the tail margin means a layout that seems to fit the paper prints a damaged last row on the press.
Printer's marks such as crop marks, the colour bar and the job slug must stay inside that boundary too. The colour bar often goes on the tail side; its width then comes off the print area as well.