Skip to content
AYARUX

Saddle stitch or perfect binding? Choosing by page count, paper and imposition

Catalogue, magazine, brochure or booklet: how the job is bound is the first imposition decision. Both methods start from the same signatures, but page order, creep and allowances are worked out very differently.

Last updated:

Saddle stitch: nested signatures

In saddle stitching, signatures are nested inside each other and stapled through the spine. The page count must be a multiple of 4; it's fast and cheap for thin jobs (up to roughly 64 pages, depending on the paper).

Because signatures are nested, the inner pages push outwards. This is creep; ignore it and the inner pages lose margin after trimming.

Perfect binding: stacked signatures

In perfect binding, signatures are stacked, the spine is ground off and glued into the cover. It suits thick jobs, books and catalogues that need text on the spine.

With no nesting there's no creep, but an allowance goes to the glue at the spine, and spine width comes from paper thickness and page count.

Which to choose?

The decision usually comes down to page count and paper thickness.

  • Thin job, few pages, tight budget: saddle stitch.
  • Thick job, catalogue or book that needs a printed spine: perfect binding.
  • Heavy cover, light text paper: either works; calculate the spine first.
  • Page count not a multiple of 4: add blank pages or change the signature plan.

What changes in imposition

The binding sets where pages sit on the signature: in saddle stitching the first signature carries both the first and the last pages; in perfect binding each signature carries its own run of pages.

So settle the binding before you impose; if it changes later, page order, fold lines and allowances are all recalculated.