Skip to content
AYARUX

How to calculate open cover size: saddle stitch, perfect binding and covers with flaps

A cover is printed open, not at the closed size of the book. Get the open size wrong and the spine text drifts, a flap comes up short or the cover won't fit the sheet. The sum is only a few additions; what matters is adding the right parts for the binding.

Last updated:

The parts of an open cover

From left to right, an open cover runs back cover, spine, front cover. Flaps, if any, go on each end. The height is the trimmed height of the book, with bleed added:

Open width = (flap) + back + spine + front + (flap)

Open height = book height

Saddle stitch has no spine allowance

On saddle-stitched magazines and brochures the cover folds down the middle, with no separate spine. The sum for an A5 brochure (148 × 210 mm) is short.

  • Net open size: 148 + 148 = 296 × 210 mm.
  • With 3 mm bleed: 302 × 216 mm.

Perfect binding adds the spine

In perfect binding the spine sits between the two cover faces. Work it out from the page count and paper, then confirm the final figure with the bindery. For an A5 book with a 13 mm spine:

  • Net open size: 148 + 13 + 148 = 309 × 210 mm.
  • With 3 mm bleed: 315 × 216 mm.

Flaps extend both ends

A flap is the part of the cover that folds inside. Add 80 mm flaps to the same A5 book and the width grows while the height stays the same:

  • Net open width: 80 + 148 + 13 + 148 + 80 = 469 mm.
  • With 3 mm bleed: 475 × 216 mm.

Details that get forgotten

Heavy cover board may need a small allowance for the fold; settle this and the flap size with your bindery. Some binderies also score a hinge line near the spine on the front and back. Keep text off that line and off the spine lines.

If the page count or paper changes, so does the spine, and the open width and layout need recalculating. The binding type matters too: a hardcover is calculated separately, from the board and the wrap allowance.

Will it fit the sheet?

The open size also decides how many covers fit on a sheet. A 475 × 216 mm cover gets at most 6 up on a 70 × 100 cm sheet, and gripper and trim margins can affect that number.

A cover folds more cleanly when the paper grain runs parallel to the fold, so don't choose a layout on quantity alone.