Skip to content
AYARUX

What is the maximum print area? Press sheet size, printable area and margins

A press catalogue lists two separate figures: the largest sheet the press can take and the largest area it can print on that sheet. They are not the same. When you impose a job, it has to fit the print area, not the sheet; the few millimetres between them can change how many pieces come off a sheet.

Last updated:

Sheet size and print area are not the same thing

The maximum sheet size is the largest paper the feeder can pass through the press. The maximum print area is the largest area the plate and blanket can put ink on, and it is always smaller than the sheet.

A press in the 70 × 100 class, for example, typically prints an area a few centimetres smaller. The exact figure varies from press to press, so imposition should use the value of your own press.

Gripper and tail margins

On an offset press the sheet is held along its leading edge by grippers; nothing can be printed on that strip. A tail margin is left on the back edge too. Together they decide where the print area falls on the sheet.

There is often a small blank strip along the sides as well. The marks, cut lines and colour bar on the sheet also have to find room inside this area.

  • Maximum sheet: the largest paper the press can pass.
  • Minimum sheet: the smallest paper it can feed reliably.
  • Gripper margin: the leading strip held by the grippers, which cannot be printed.
  • Tail margin: the blank left on the back edge.

Why catalogue figures should be measured

The print area in a catalogue is for a new, ideally set press. The age of the press, the gripper setting or the plate type can make the real area differ by a few millimetres.

On a tight job that difference matters: a layout that fits according to the catalogue can end with the bleed of an edge piece cut off on press. Printing a test sheet on your own press and measuring the real area is the safest route.

Allowing for the print area in imposition

When placing a job on the sheet, the measure is the print area, not the sheet: every piece, bleed included, has to stay inside it.

When the sheet is turned, as in work-and-tumble, the opposite edge becomes the gripper too; margins are then needed on both edges and the usable area shrinks. Digital presses have no gripper, but they leave an equal non-printable strip on all four edges.

When there is more than one press

If the shop runs several presses, the print area and the gripper and tail margins of each should be recorded separately. A job that fits eight up on one press may drop to six on another, and that changes the paper needed and the cost directly.