Skip to content
AYARUX

How do you impose labels? Fitting the most labels on the sheet with the least waste

A jar label, a bottle label or a product tag: in label work the design is one, but it is laid on the sheet dozens of times. How many fit, how much gap you leave and which sheet you choose decide both the waste and the cost of the job. A few millimetres can make a difference of hundreds of sheets across a run.

Last updated:

What is label imposition?

Label imposition is placing a single label design on the press sheet in rows and columns, as many times as possible. The layout is named after the count on the sheet: “24-up”, “40-up”.

The aim is not only to fit many labels: the layout must suit the cutting, leave room for the edge the press grips (the gripper) and give every label the same size after trimming.

How many fit?

The simple sum: divide the usable width of the sheet by the label width and the usable height by the label height, then multiply the whole numbers. The usable area is what remains once the gripper margin and edge margins are taken off.

Turning the label 90 degrees often changes the answer. On the same sheet a landscape layout might give 32 and a portrait layout 36; try both directions before deciding.

Gutters and bleed between labels

If the label's background runs to the edge, every label needs bleed around it so that a slight shift in cutting leaves no white line. Labels are then spaced by twice the bleed and each gap takes two cuts.

If the label has a white or plain border, labels can be butted edge to edge and one cut separates two labels. That means both more labels on the sheet and fewer cuts.

Gripper margin and trim marks

An offset press holds the sheet by one edge, and nothing prints on that strip. The layout must start beyond this margin, or the first row of labels gets clipped.

Trim marks show the guillotine operator where to cut. They go at the start and end of every row and column; with bleed, they mark the label's finished size, not the bleed edge.

Choosing the sheet and counting waste

The same label comes out a different number of times on different sheet sizes. A layout that wastes little on 70 × 100 cm may leave a wide unused strip on 64 × 90 cm, and most of the paper cost sits in that unused area.

To count sheets, divide the run by the number up and add spoilage for make-ready and cutting. Spoilage depends on the job and the press; your own past jobs are the best guide.