Skip to content
AYARUX

How to plan a guillotine cutting sequence: fewer cuts and accurate sizes from a printed sheet

However good the print, the job ends at the guillotine. Cutting in the wrong order shifts sizes, leaves edges out of square and wastes time. The cutting sequence depends on how the sheet was laid out, so the best plan starts at imposition.

Last updated:

Protect the reference edges

The press holds the sheet by the gripper edge and the side lay. These two edges are where the print sits most consistently on the sheet, so the cutter usually makes the first cuts with them against the guillotine's back gauge and side guide.

That's why sheet corners shouldn't be crushed before cutting and the stack should be aired and jogged square. If a reference edge is off, every cut inherits the error.

The general order

Every finishing room has its own habits, but most jobs are cut along these lines:

  • Split a large sheet into manageable blocks if needed.
  • Trim the outside of the block: one long edge first, then turn 90° and cut the edge next to it, giving a square corner.
  • Cut the remaining two outside edges from that corner.
  • Cut the block into strips.
  • Cut the strips to final size, one at a time or laid side by side.

Single cut or double cut?

If items touch with no gap between them, one cut separates two items. That's only safe when both edges end in the same colour or the job has no bleed.

Jobs with bleed need a gutter between items; each gutter is cut twice and the strip in between is waste. Double cuts mean more cuts, but each item keeps its bleed on its own edge.

Counting the cuts

Take 12 business cards laid out 3 columns by 4 rows. The outside edges need 4 cuts.

If the cards touch, there are 2 cut lines between columns and 3 between rows: 4 + 5 = 9 cut lines. With gutters, each one is cut twice: 4 + 10 = 14 cut lines. If strips are cut separately, the actual number of guillotine cuts is higher still.

Imposition choices that make cutting easier

Cutting follows from the decisions made at imposition. Laying items on a regular grid in the same direction keeps cutting simple; when one sheet carries different sizes, grouping them in the same row or column lets them share cut lines.

Clear trim marks on the outside, a gripper margin that stays out of the cuts and enough bleed all make a direct difference at the guillotine.

A last check before cutting

Measure the first finished piece against the job ticket. In a tall stack the cut can draw slightly under the blade's pressure, so splitting the stack to suit the job's tolerance gives cleaner results.

For double-sided work, check on the first sheet that the back registers with the front; the guillotine can't fix a misregistered back.